User Manual TXLD0012
Page | 64 Novoxel.com P/N T2-UM-E-ENG Rev 10
The device is intended for use in the electromagnetic environment specified below. The operator of the
device should assure that the device is used in such an environment.
Use of this device adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this device
and the other equipment should be observed to verify that they are operating
normally.
The use of accessories other than those specified for the device is prohibited. They
may result in increased electromagnetic emissions or decreased electromagnetic
immunity of the device.
Immunity Test IEC 60601 Level Compliance Level
Electromagnetic Environment -
Guidance
Electrostatic
discharge (ESD),
IEC 61000-4-2
8 kV contact
15 kV air
8 kV contact
15 kV air
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30%.
Electrical fast
transient/burst,
IEC 61000-4-4
2 kV for power
supply lines
1 kV for SIP/SOP
lines
2 kV for power
supply lines
Mains power quality should be that of a
typical commercial or hospital
environment.
Surge,
IEC 61000-4-5
1 kV line to line
2 kV line to earth
1 kV line to line
2 kV line to earth
Voltage dips and
interruptions on
power supply input
lines
IEC 61000-4-11
0% U
T
for 0.5
cycle
0% U
T
for 1 cycle
70% U
T
for 25/30
cycles
0% U
T
for 250/
300 cycles
0% U
T
for 0.5
cycle
0% U
T
for 1 cycle
70% U
T
for 25/30
cycles
0% U
T
for 250/300
cycles
Mains power quality should be that of a
typical commercial or hospital
environment. If the user of the equipment
requires continued operation during
power mains interruptions, it is
recommended that the equipment be
powered from an uninterruptible power
supply or a battery.
To Next Page
Loading...