NSD VARICAM VS-5F Series User Manual

64
OPERATION 8. HOW TO USE APPLIED FUNCTIONS (PARAMETER)
8-2. Selection of the Program No. Input Method
This method is available for VS-5FD, VS-5FD-1, VS-5FX, and VS-5FX-1.
Selects the input format of the program number to be operated.
● Parameter list
No. Name Description Setting range
Initial
value
Reference for
setting procedure
(Chapter No.)
97
Program No.
input format
Selects the input format of
the program number to be
operated.
0: By panel key input
1: By external connector input
2: By serial communication
0
8-1-1
8-1-2
When the Program No. is changed by an external (BCD output connector), the timing will be as shown below.
Change to Program No.4.
Turns OFF the power supply
Approx. 0.01s
Approx. 0.5s
Approx. 2.7s
Approx.
2 0μs
The switch output turns ON/OFF
according to the setting values.
Ex. Turns ON the power supply and
the program No.2 is selected.
Program No. input
1
2
4
Power supply
System
ready output
Switch output
Switch
output
Timi
ng pulse output
CAUTION
When the program No. is changed, the system ready signal turns OFF approximately 0.5 seconds.
The switch output (Arbitrary pulse output) and timing pulse are “HOLD” status during the time.
Use care when changing the program No..
CAUTION
When “2” or “3” is selected at the parameter No. 85 (Protocol), parameter No. 97 (Program No.
input format) is disabled and the selecting program No. is fixed to ”0”
POINT
In the case of selecting “0: By panel key input” and setting the password, the password must be input when
changing the program No.. Refer to “ APPENDIX 1” for the password.

NSD VARICAM VS-5F Series Specifications

General

Brand	NSD
Model	VARICAM VS-5F Series
Category	Switch
Language	English