NSK Surgic Pro+ - Foot Control Unit Details; Installation; Connecting the Motor Cord

3-3 Foot Control
Coolant Solution Flow Volume Button
Use to select 6 levels of coolant solution flow from 0 to 5; each level may be increased by one step pressing this
button. If you press this button in level 5, it returns to level 0.
PRG (Program) Button
Use to select the desired program number. Program numbers will always ascend each time this button is pressed and
released. To descend, press and hold for 1 second then release.
Speed Control Pedal
Use to start and stop the Micromotor and to control the speed during operation. The Micromotor operational speed is
directly proportional to the position of the foot control, up to the preset maximum.
Forward/Reverse Button
Use to change the rotational direction of the Micromotor. Push once to change the rotational direction.
(a)
(b)
(c)
(d)
(b) PRG (Program) Button
(c) Speed Control Pedal
Foot Control Cord and Plug
4. Installation
Align the [
●
] mark on the Motor Cord with [
●
] mark on the
Control Unit.
Push the Base of Motor Cord Plug into the socket until the
locking joint ‘clicks’ into place.
To disconnect the plug; pull back the Lock Joint, pull further
to disconnect the cord.
4-1 Connecting the Motor Cord
(a) Coolant Solution Flow
Volume Button
(d) Forward/Reverse Button
7
CAUTION
Install the cord/plug only power is OFF.
English
[
●
] mark
Lock Joint
Fig.1