20
13. Troubleshooting
When trouble is found, please check the followings prior to consulting your dealer.
Problem Probable Cause Cause Solution
No / Poor
vibration.
The Front Panel
does not light,
even if the Power
Switch is ON.
The Power Cord or the Jack is
disconnected.
Correctly insert the Power Cord or the Jack.
The Fuse is burned out. Contact dealer.*
The Tip does
not generate
vibration, in spite
of depressing
the Foot Control.
The Tip is not tightened firmly. Tighten the Tip until the Tip Wrench clicks.
Worn Tip. Replace the Tip.
Power has not been correctly
adjusted for the Tip.
Adjust the power on the Power Guide or Tip
case label. Do not exceed.
The Foot Control is disconnected. Connect the Foot Control correctly.
Failure of vibrator in the handpiece. Contact dealer.*
Failure of internal components of
the Foot Control.
Contact dealer.*
The Tip is bent
or broken.
—
Power has not been properly
adjusted for the Tip.
Adjust the power level the Power Guide or Tip
case label. Do not exceed.
The Tip is flying
away.
— The Tip is not tightened firmly. Tighten the Tip until the Tip Wrench clicks.
Noise from the
handpiece.
—
Power has not been properly
adjusted for the Tip.
Adjust the power level on the Power Guide or
Tip case label. Do not exceed.
The Tip is not tightened firmly. Tighten the Tip until the Tip Wrench clicks.
Failure of vibration in the handpiece
or the Control Unit.
Contact dealer.*
The handpiece is
overheating.
—
Power has not been properly
adjusted for the Tip.
Adjust the power level on the Power Guide or
Tip case label. Do not exceed.
The Tip is not tightened firmly. Tighten the Tip until the Tip Wrench clicks.
Failure of vibration in the handpiece
or the Control Unit.
Contact dealer.*
No Irrigation
supply and/or
unstable
Irrigation supply
(Use of Bottle)
The Irrigation
Pump is running.
The tube twisted. Straighten the twisted Irrigation Tube.
The Irrigation
Pump is
stopping.
Time to replace Irrigation Pump.
(Approx. 500hours after used.)
Replace with new Irrigation Pump (Refer to 11.
(4) Changing the Irrigation Pump).
No / Poor water.
(Use of Tap
Water)
The water does
not reach to the
Control Unit.
—
Check the water circuitry and supply to the
Control Unit. Water pressure : 0.1-0.5MPa
(1-5kgf/cm
2
)
Check to see if
water reaches
the Control Unit.
The Water Adjustment Knob is
closed.
Turn the Water Adjustment Knob and adjust to
the appropriate volume.
Disconnected Irrigation supply at
low volume range. (less than 10ml/
min.)
No problem. Turn the Water Adjustment Knob
and increase the Irrigation volume.
The Water Filter is clogged.
Replace with new Water Filter (Refer to 11. (6)
Changing Water Filter (Option) ).
To Next Page
Loading...
Need help?
General
