Nuga N5 - Product Storage and Care; Storage and Cleaning; Indicator Window and Error Codes


N5

How to Store and Clean
the Product after Use
Check Indicator Window of Controller
Product Storage and Care
Introduction
1. Separate the power cord while the product is not in use for a long time.
2. Be aware of the following for the storage place.
ྙ Keep the product in a place with no water.
ྚ Keep the product in a place with no concern of any adverse effect such as the air
pressure, temperature, humidity, ventilation, sunlight and/or air containing dust,
salt, sulfur, etc.
ྛ Be careful of safety conditions such as the slope, vibration, shock, etc.
(including those during transportation).
ྜ Do not keep the product in a place near any chemical or gas.
ྜྷ Avoid any direct sunlight during the storage.
3. Store the product after cleaning the components.
i
'XULQJRSHUDWLRQ7HPSHUDWXUHa୅KXPLGLW\a
7UDQVSRUWDQGVWRUDJHFRQGLWLRQV7HPSHUDWXUHa୅KXPLGLW\a
DWPRVSKHULFSUHVVXUHK3DWRK3D
Environmental conditions
How to clean
Caution
Ensure unplugging of the power plug before cleaning.
Otherwise, it might cause electric shocks.
Caution
Do not disassemble the product arbitrarily if any error occurs, but remove the
power plug, turn off the power switch, and then contact your supplier.
If you disassemble the product arbitrarily, it might cause serious injuries
and/or damage to the product.
Display
Internal Projector
Auxiliary
heating part
External projector
(Abdomen heating pad)
Error code
(
Lumbar vertebrae
$EQRUPDOWHPSHUDWXUHVHQVRU
7KRUDFLFYHUWHEUDH
$EQRUPDOWHPSHUDWXUHVHQVRU
Cervical vertebrae
$EQRUPDOWHPSHUDWXUHVHQVRU
7KRUDFLFYHUWHEUDH
+HDWHUEDUGLVFRQQHFWLRQ
Cervical vertebrae
+HDWHUEDUGLVFRQQHFWLRQ
Overheating of the
internal projector
Abnormal Limit sensor
Abnormal Motor
Abnormal Controller
communication
Lumbar vertebrae
+HDWHUEDUGLVFRQQHFWLRQ
Abnormal temperature sensor behavior in the main
heating part
Disconnection in the main heating part
Abnormal temperature sensor behavior in the lower
heating part
Disconnection in the lower heating part
Overheating of the element
Disconnection in the temperature sensor of the external
projector (not connected)
Abnormal temperature sensor behavior of the
external projector
Disconnection in the lamp of the external projector
Overheating of the external projector
E1
E2
E3
E4
(
(
(
(
E9
(
E1
E2
E3
(
E1
(
(

Feet pad
Apply a little of water
to dry cloth and softly
wipe it out.
Outside cover
Separate and wash
the outside cover.
Device body
Apply a little of water
to dry cloth and softly wipe it out.