5 - 72 en-938821/2
5.9.1 Programme Creation or Editing
Requirements
"GRAPHIC PROGRAMMING" menu displayed (See 5.9).
One of the Auto, Single, Dryrun or Manual modes selected or no mode selected.
Actions
Select "BACKGROUND EDIT". ☞
%
5
Display of the message:
ENTER PROGRAM NUMBER
Enter "% [Programme No.]" (to be created or edited). ☞
Programme editing
Display of the programme listing where the block pointer is displayed as "=".
Make the changes in edit mode (See 5.4.2.2).
Programme creation
Display of the message:
No programme with that number exists A programme with the same number
in the protected area exists in the protected area
Display of the message: Display of the message:
CREATE NEW PROGRAMME? (Y/N):
❚
WARNING: this programme exists in a protected zone.
Create the programme in zone 0?(Y/N):
❚
Confirm creation of the programme. ☞
Y
Display of the line:
=%[Programme No.]
Create the programme blocks using the edit mode functions (See 5.4.2.2).
Notes
Programme duplication
When a programme is being executed, any programmes created or modified in background are duplicated
programmes: the duplication of the active programme allows modification while the active programme is being
executed.
The duplicated programmes are displayed in the directory page (See 4.5.1) and indicated by "%- [Programme No.]"
which differentiates them from normal/programmes which can be executed (% [Programme No.]).
When current programme execution has been completed (status: M02), the duplicated programmes are enabled and
can then be executed.
To Next Page
Loading...
