NUM 1020 M - 6.4 No Cycle Start

en-938821/2 6 - 11
Operational Problems
6
6.4 No Cycle Start
Failure symptoms
Any machining mode selected.
The cycle is not started ("INCYC" indicator absent from the status window) by pressing the "CYCLE" button on the
machine panel.
Trouble-shooting
Analyse and
remedy the fault.
Examine the PLC
programme to
determine the origin
of the fault.
Call NUM
customer support.
Yes
No
NOBSTOP = 0
?
Display
"PLC MEMORY" page
☞
Display the no stop at end
of block condition:
NOBSTOP
Is the
NC ?? indicator
displayed
?
Display the error number
and the block with the error on
one of the following pages:
-
current position
- data
- programme
AXIS
INFO.
PROG.
Yes
No
☞
☞
☞
PLC
I/O
@
2