NUM 1020 M - 5 CNC Operation

CNC Operation
en-938821/2 5 - 1
5
5 CNC Operation
5.1 Preliminary Operations 5 - 5
5.1.1 Operator-Controlled Jog 5 - 5
5.1.1.1 Selection of JOG Softkeys 5 - 5
5.1.1.2 Selection of Manual Mode 5 - 6
5.1.1.3 Incremental Jog 5 - 6
5.1.1.4 Continuous Jog 5 - 7
5.1.1.5 Handwheel Jog 5 - 7
5.1.2 Axis Homing 5 - 8
5.1.2.1 Homing on to a Switch 5 - 8
5.1.2.2 Origin Declaration via the Keyboard 5 - 9
5.1.2.3 Automatic Homing 5 - 9
5.2 Preparation for Machining 5 - 10
5.2.1 Part setting with Respect to the Machine 5 - 10
5.2.1.1 Selection of Origin Shift Mode (SHIFT) 5 - 11
5.2.1.2 Part Origin Shift Introduction 5 - 12
5.2.1.3 Input of Part Origin Shifts via the Keyboard 5 - 13
5.2.1.4 Input of Programme Origin Shifts 5 - 13
5.2.1.5 Input of Programme Origin Eccentricity
Values 5 - 14
5.2.1.6 Input of Scaling Factor 5 - 14
5.2.1.7 Declaration of Axis Assignment 5 - 15
5.2.2 Tool Setting 5 - 16
5.2.2.1 Semi-Automatic Tool Dimension Entry 5 - 16
5.2.2.2 Tool Dimension Entry via the Keyboard 5 - 19
5.2.2.3 Loading the Tool Offsets via Peripheral or
Computer 5 - 20
5.2.2.4 Tool Wear Offset Entry 5 - 21
5.3 Manual Data Input 5 - 24
5.4 Automatic Programme Execution 5 - 25
5.4.1 Loading Programmes 5 - 25
5.4.1.1 Loading Part Programmes 5 - 26
5.4.1.2 Selection of Active Programme 5 - 28
5.4.1.3 Reading a Programme in Drip Feed Mode 5 - 29
5.4.2 Creating and Debugging a Part Programme 5 - 32
5.4.2.1 Access to Edit Mode 5 - 32
5.4.2.2 Creating or Editing a Part Programme 5 - 32
5.4.2.3 Programme Deletion 5 - 39
5.4.2.4 Programme Renaming 5 - 39
5.4.2.5 Duplication of a Part Programme 5 - 40
5.4.2.6 Programme Test 5 - 40
5.4.3 Execution on the Machine 5 - 42
5.4.3.1 Optional Stop and Block Skip Enable 5 - 42
5.4.3.2 Programme Execution - General 5 - 43
5.4.3.3 Execution of a Programme Step by Step 5 - 46
5.4.3.4 High Speed Execution of a Programme 5 - 47
5.4.3.5 Execution of a Programme in
Automatic Mode 5 - 48