5 - 98 en-938821/2
There is no active programme.
Display in the dialogue window of the message:
No current programme. Press any key
Acknowledge the message. ☞
Key
No programme is unloaded.
End of the Procedure
Exit from the page ☞
OUT
Exiting from the page does not interrupt unloading in progress.
5.9.7.2 Unloading Other Programmes to the NUM Diskette Drive
Actions
Select "OTHER PROGRAMME". ☞
@
2
The "SERVICE DISKETTE: UNLOAD PROGRAMME" page is displayed with the softkeys:
CD
DIR CD..
HELP
OUT
TRANSF.
CD \
ABORT
and the dialogue line:
Transfer >❚
Press the
HELP
key for help on the softkeys displayed, which are the same as for active programme unload (See
5.9.7.1) except:
<TRANSF> : [Programme-filename]:(CNC source), (target) programme to be unloaded
e.g.: %10.1 p101.pie - %% tou.pie - %10.* gr10.pie
Commands Already Described
Commands CD.., CD and CD\ are described in 5.9.5.3 and command "DIR" is described in 5.9.5.4.
Unloading Programmes
This operation requires the presence of a formatted diskette in the drive. It is used to save one or more programmes
in a file on the diskette.
Select the target directory for the file to be unloaded (See 5.9.5.3).
Select programme unload. ☞
TRANSF.
Display in the dialogue window of:
Transfer >Filename: ❚
Enter the name of the file to be loaded (See syntax). ☞
To Next Page
Loading...
