5 - 100 en-938821/2
5.9.7.3 Saving Tool Offsets to NUM Diskette Drive
Actions
Select "TOOL OFFSETS". ☞
!
1
The "SERVICE DISKETTE: UNLOAD CORRECTORS" page is displayed with the softkeys:
CD
DIR CD..
HELP
OUT
TRANSF.
CD \
ABORT
and the dialogue line.
Transfer >❚
Press the
HELP
key for help on the softkeys displayed, which are the same as for active programme unload (See
5.9.7.1).
Commands Already Described
Commands CD.., CD and CD\ are described in 5.9.5.3 and command "DIR" is described in 5.9.5.4.
Unloading Tool Offsets
This operation requires the presence of a formatted diskette in the drive. It is used to save tool offsets in a file on the
diskette.
Select the target directory for the file to be unloaded (See 5.9.5.3).
Select tool offset unload. ☞
TRANSF.
Display in the dialogue window of:
Transfer >Filename: ❚
Enter the name of the file to be saved (See syntax). ☞
Syntax
[filename].[ext]
[filename] tool offset target filename
[ext] tool offset target file extension
Display of the message:
unloading tool offsets:
[filename].[ext]
in progress...
When unloading is complete, the dialogue line is cleared.
The tool offsets are saved
To Next Page
Loading...
