4001 non-addressable control and indicating equipment
Installation and Service Manual
© 2015 ~ 2018 Ambest Electronics (Ningbo) Co Ltd. All rights reserved.
All specifications and other information shown were current at the date of publication and subject to change without notice.
Contents
1.
INTRODUCTION ........................................................................................................................................ 1
1.1. Features ........................................................................................................................................... 1
1.2. Factory Default Settings .................................................................................................................. 1
2. OPTIONAL INTERFACES .......................................................................................................................... 2
2.1. Remote LED Display ....................................................................................................................... 2
2.2. Detection Zone Output Card ............................................................................................................ 2
2.3. Repeater Panel ................................................................................................................................ 2
3. CONTROLS AND INDICATORS ................................................................................................................ 2
4. ACCESS LEVELS ...................................................................................................................................... 4
4.1. Access Level 1 ................................................................................................................................. 4
4.2. Access Level 2 ................................................................................................................................. 4
4.3. Access Level 3 ................................................................................................................................. 5
5. CONDITIONS ............................................................................................................................................. 7
5.1. Quiescent Condition ........................................................................................................................ 7
5.2. Alarm Condition ............................................................................................................................... 7
5.3. Fault Condition ................................................................................................................................. 7
5.4. Disabled Condition ........................................................................................................................... 8
5.5. Test Condition .................................................................................................................................. 9
5.6. Delays Active/Inactive ...................................................................................................................... 9
5.7. Inactivity Timeouts ........................................................................................................................... 9
6. INSTALLATION ........................................................................................................................................ 10
6.1. Safety ............................................................................................................................................. 10
6.2. Tools and Equipment ..................................................................................................................... 10
6.3. Control and Indicating Equipment Mounting.................................................................................. 10
6.4. Control and Indicating Equipment Power-Up ................................................................................. 11
6.5. General Wiring Requirements ........................................................................................................ 11
6.6. Mains Wiring ................................................................................................................................... 11
6.7. Detection Zones .............................................................................................................................. 1 1
6.8. Alarm Zones .................................................................................................................................. 12
6.9. Ancillary Outputs ............................................................................................................................ 12
6.10. Ancillary Inputs .............................................................................................................................. 13
6.11. Remote Display Output .................................................................................................................. 13
6.12. Detection Zone Output Card .......................................................................................................... 13
6.13. Repeater Output ............................................................................................................................ 14
7. PRE-COMMISSIONING ........................................................................................................................... 14
8. CONFIGURATION .................................................................................................................................... 15
8.1. Alarm Dependency (Zone Coincidence Detection) ....................................................................... 15
8.2. Non-Latching Detection Zones ...................................................................................................... 15
To Next Page
Loading...
Need help?
General
