Numens 4001 Series User Manual

4001 non-addressable control and indicating equipment
Installation and Service Manual
7 32-0002-r12_2018-09
© 2015 ~ 2018 Ambest Electronics (Ningbo) Co Ltd. All rights reserved.
All specifications and other information shown were current at the date of publication and subject to change without notice.
5. CONDITIONS
5.1. Quiescent Condition
The Quiescent Condition is the normal condition for the control and indicating equipment. In the Quiescent
Condition, only the SUPPLY LED is on.
5.2. Alarm Condition
When the control and indicating equipment enters the Alarm Condition, the alarm sounders and output modules
will operate according to their configuration programming.
5.3. Fault Condition
When a fault occurs with a device or within the control and indicating equipment, the control and indicating
equipment will enter the Fault Condition. In the Fault Condition, the internal sounder will operate.
The FIRE LED will
flash. The internal
sounder will
operate.
The ZONES FIRE LED
(
s
)
will flash.
The ACTIVATE/SILENCE
ALARMS LED will
illuminate.
The FAULT LED
will flash. The
internal sounder
will operate.
The fault type will
be displayed as a
flashin
g
LED.
If the fault is a Zone
Fault, the Zone LED
will flash at 1 Hz.
The BUZZER
SILENCE LED will
flash.
Pressing the
BUZZER SILENCE
button will
acknowledge the
alarm and silence
the sounder.
The BUZZER
SILENCE LED will
flash.
Pressing the
BUZZER SILENCE
button will
acknowledge the
fault and silence the
sounder.

Numens 4001 Series Specifications

General

Brand	Numens
Model	4001 Series
Category	Control Unit
Language	English