Page 48 of 54
Problem
Fluctuating results after repetitive balance runs
Remedy
Make sure that the correct cone has been used for the wheel and that the clamp is secure and tight on
the clamping means.
− Check that the machine is on level hard ground. If necessary bolt machine to the ground. Never
use machine when it is bolted on a wooden pallet.
− Check the software version. Update if it is lower than 1.6. Software can be downloaded from our
home page.
− Check Piezo sensors - Make sure they are tightened to exactly 2 Nm and that the securing nut is
tight. Check the cables and connectors that they are secure and in good condition.
− Check the bearing play in the main shaft. IF there is too much play, make sure that the belt pulley
securing bolt is tightened to 10Nm securing with Loctite. If the bearing play cannot be relieved,
change the mains haft assembly.
− Make sure that the clamping means is clean and tight on the main shaft. Check the tightness of
the securing bolt and clean clamping means completely with a clean dry cloth.