NUTRIBULLET NutriCook - Install and Remove Float Valve

Install and remove
oat valve.
When pressure builds up inside your
cooker, the oat valve pops up. This
indicates the cooker is pressurized
and prevents you from opening the
lid. When the cooker is depressurized,
the oat valve drops down.
Note: Refer to Venting methods section of
this user guide to safely release pressure.
Remove: Press the lid release button
and turn lid over. Detach the silicone
cap from the oat valve and remove
oat valve from top of lid.
Note: Always keep the oat valve and
silicone cap in a secure place after
removing from the lid.
Clean oat valve
to remove dried food debris after every
use to avoid clogging. The oat valve and
silicone cap must be installed in the lid
before operating your cooker.
Install: Insert oat valve on the hole
located on top of the lid. Press the lid
release button and turn lid over. On
the bottom of lid, attach the silicone
cap to the oat valve.
Note: The oat valve and silicone cap must
be installed in the lid before operating your
cooker.
Warning: Never touch the oat valve
while the cooker is pressurized to avoid burns.
24