NUTRIBULLET NutriCook - Troubleshooting Common Issues; Lid Opening and Closing Problems; Steam Leaks and Float Valve Issues; Pressure Release and Minor Leaks

Troubleshooting.
Issue Possible Cause Solution
Diculty closing lid.
The sealing ring is not properly
installed
Check the position of the sealing ring and ensure
it is properly installed in the sealing ring rack.
The oat valve is in the popped-up
position.
Gently press the oat valve downward using a
long utensil.
Diculty opening
lid.
There is still pressure inside the
cooker.
Release pressure by turning the pressure release
valve in Venting position. Ensure that the oat
valve dropped down before opening the lid.
WARNING: Contents inside the pot under pressure
can cause scalding injury, do not attempt to force
lid open. Always follow the Safe Lid Opening
instructions in this user guide.
The oat valve is stuck in the
popped-up position due to food
debris or residue.
Ensure steam is completely released by quick
releasing pressure, then press oat valve gently
using a long utensil. Open lid cautiously and
thoroughly clean oat valve, surrounding area,
and lid before next use.
Inner pot sticks
with the lid when
opening.
The inner pot may create suction
while cooling, causing it to stick
to the lid.
Turn pressure release valve to Venting position to
completely release pressure.
Steam leaks from
side of lid.
There is no sealing ring in lid. Install sealing ring properly.
The sealing ring is damaged or not
properly installed.
Replace sealing ring. Contact Customer Service
to replace damaged sealing ring.
Food debris attached to sealing
ring.
Remove sealing ring and clean thoroughly.
The lid is not properly closed. Reposition lid and lock properly.
The oat valve does
not rise
There is food debris on oat valve. Clean oat valve thoroughly.
Too little liquid in the inner pot.
Add thin, water-based liquid to inner pot based
on size:
6L - 350 ml | 8L - 475 ml
Minor steam is
leaking from the
pressure release
valve
The pressure release valve is
not properly pointed to Sealing
position.
Make sure pressure release valve is properly in
Sealing position.
The cooker is regulating excess
pressure.
This is completely normal. No action required.
43