NUTRIBULLET NutriCook - Troubleshooting: Steam Escapes and Error Codes; Steam Escape and Valve Seating; Clicking Sounds and Wet Pot Bottom; Error Codes and Lid Status

Issue Possible Cause Solution
Steam escapes from
the pressure release
valve while it is in
Sealing position
The pressure release valve is not
properly seated
Turn the pressure release valve properly to
Sealing position.
Pressure sensor control is not
working
Contact Customer Service.
Clicking or light
cracking sounds is
produced
The power switching and
expanding pressure while
changing temperature can
produce this sound
This is completely normal. No action required.
Exterior bottom of the inner pot
is wet.
Ensure to wipe the exterior surface of the inner
pot before inserting to the heating element.
LCD display
ashes error
codes and
cooker beeps
continuously.
E1 - Temperature Sensor
Open Circuit.
WARNING:
Stop working after these codes appear.
Disconnect from power supply. Contact
customer service.
E2 - Temperature Sensor
Short Circuit.
E3 - Overheating.
E4 - Signal switch mal-
function.
Lid - The lid is not closed
properly.
Reposition the lid and ensure it is properly locked
for all pressure cooking programs.
NOTE: Do not lock the lid when using the SAUTÉ
function.
44