16
The set time start to count after the device reaches the set temperature.
6.4 COMPLETION OF THE OPERATION
Observe that the set program is completed (See “End” and “End of the program
lamp”).
Push the heating process stop key in order to stop the heating. If the device
functions with shaking, push the shaking process stop key to stop the shaking
process.
Take the samples out at the required temperature and time.
When the device is unloaded, remove the undesirable effects which are caused by
the samples.
You may leave the device at stand-by position or switch it off.
Operating records are transferred to the usb port attached a USB memory.
Check the liquid level in the tank during long operations and refill to the max line if
necessary.
The usb led and the data transfer led on the control panel turn on during transfer of data
in memory and the transfer process starts automatically. Do not remove external
memory from usb port without the data transfer led turn off and the audible alarm
finished.
Records are transferred to external memory when external memory is connected to the
Usb port. For get the records without program ending, Usb memory, hold down the
"Mute" button for 3 seconds until "Data Transfer Lamp" lights up, then remove from Usb
port.
To Next Page
Loading...
