Nvidia Jetson AGX Orin Series User Manual

DisplayPort and Embedded DisplayPort Tuning Guide
PRELIMINARY INFORMATION
Jetson AGX Orin Series Tuning and Compliance Guide DA-11040-001_v0.7 | 42
Final Steps
This section describes the final steps for DP and eDP tuning.
Sanity Check
After tuning is completed, the settings should be sanity-checked to make sure they do not
violate any other parts of the DisplayPort specifications and that there is a comfortable
amount of margin based on the user’s analysis.
The DUT should go through the battery of electrical tests outlined in the DP CTS document to
ensure that the DUT will pass DP certification.
If there are any failures, the settings must be tuned again until there is a passing result.
Updating the Software
After the tuned settings have been verified, they must be updated in the OS or the driver.
Final Check
After the settings have been updated in the driver, verify that the tuned settings are applied for
each of the requested modes.
A visual check-out is recommended as well. Connect the DUT to a DP or eDP panel and
visually verify that there is no corruption at any of the supported bitrates.

Nvidia Jetson AGX Orin Series Specifications

General

Memory	32GB 256-bit LPDDR5
Storage	64GB eMMC 5.1
Networking	10/100/1000BASE-T Ethernet
Dimensions	100 mm x 87 mm
GPU	NVIDIA Ampere architecture with 64 Tensor Cores
CPU	12-core Arm Cortex-A78AE v8.2 64-bit CPU
AI Performance	275 TOPS
Power	15W to 60W
Video Encode	2x 4Kp60 | 8x 1080p60 | 16x 1080p30 (H.265/H.264)
USB	2x USB 2.0
PCIe	PCIe Gen 4
Operating System Support	Ubuntu