NXP Semiconductors PN5180 - Page 44

NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 44 / 45
Tables
Tab. 1. Test input ........................................................ 27
Tab. 2. Send Data input .............................................. 27
Tab. 3. Read Data input .............................................. 27
Figures
Fig. 1. PNEV5180B Customer Evaluation Board ......... 5
Fig. 2. PNEV5180B 2.0 top view ..................................5
Fig. 3. LPC1769 ............................................................6
Fig. 4. JTAG interface and Serial EEPROM .................7
Fig. 5. Power supply .....................................................8
Fig. 6. PNEV5180B 2.0 PN5180 .................................. 9
Fig. 7. Antenna ............................................................. 9
Fig. 8. PN5180 evaluation board antenna tuning ....... 10
Fig. 9. PNEV5180B 2.0 Default jumper settings .........11
Fig. 10. PNEV5180B 2.0 jumper settings for external
power supply ................................................... 12
Fig. 11. PNEV5180B with new LPC FW connected
to the PC .........................................................13
Fig. 12. NFC Cockpit warnings in the Log Monitor ....... 13
Fig. 13. NFC Cockpit Secondary FW (LPC FW)
update ..............................................................14
Fig. 14. LPC Bootlader mode .......................................15
Fig. 15. LPC 1769 as USB device (from default LPC
FW) ..................................................................16
Fig. 16. NFC Cockpit Initial view .................................. 17
Fig. 17. PN5180 NFC Cockpit: Activation of a
MIFARE DESFire EV1 card + Get
Application ID .................................................. 18
Fig. 18. PN5180 register access .................................. 19
Fig. 19. PN5180 direct EEPROM access .....................20
Fig. 20. PN5180 DPC ...................................................21
Fig. 21. PN5180 AWC ..................................................22
Fig. 22. PN5180 analog and digital test signals ........... 24
Fig. 23. Basic Rx Matrix Test set up ............................ 26
Fig. 24. Enhanced Rx Matrix Test setup with AWG ......26
Fig. 25. NI VISA installation ......................................... 29
Fig. 26. AWG setup for type A @ 106 ......................... 30
Fig. 27. AWG setup for type B @ 106 ......................... 32
Fig. 28. Rx Matrix test run example with AWG .............33
Fig. 29. Rx Matrix Result example with AWG .............. 34
Fig. 30. PN5180 LPCD .................................................35
Fig. 31. Secondary Firmware tab with EMVCo
Loopback function ........................................... 37
Fig. 32. PN5180 jumper settings with external TVDD ... 39
Fig. 33. LPC driver ....................................................... 41
Fig. 34. Wrong driver installed ..................................... 42