Nytech DS-8310 User Manual

Nytech DS-8310 Introduction
10 - English
The status indicator of the charging cradle will light orange whilst the
battery is charging. When the charging process is completed, the status
indicator will light green. You can then insert the rechargeable battery into
the Nytech DS-8310. Depending on the charge level, the charging cycle
can take up to 4 hours.
If, after inserting the rechargeable battery, the indicator remains green, this
means the rechargeable battery is already charged or it is not correctly
inserted. In this case, check the polarity.
Inserting the Battery
When the battery is fully charged, insert it into the Nytech DS-8310 as
below.
- Open the Nytech DS-8310 battery compartment by pushing the cover
gently outwards. The cover will spring up by a spring mechanism.
- Move the unlock button (see the figure below) to the side and then place
the rechargeable battery with the marking orientated towards the camera
front panel into the battery compartment. Insert the battery fully into the
housing. The rechargeable battery should be inserted gently and without
offering resistance.
- Close the battery compartment cover by pressing down the flap on the
housing of the camera and then by pushing it inwards till it locks. The
cover clicks into place.
Unlock button

Nytech DS-8310 Specifications

General

Brand	Nytech
Model	DS-8310
Category	Digital Camera
Language	English