Nytech DS-8310 Capturing Pictures
20 - English
Using the Flash
The flash [14] doesn't only enhance the brightness under bad lighting
conditions, but you can also use it for backlight shots or when the subject is
located in shadow. In Recording mode, press the flash button (see the
figure below) to toggle through the different flash modes of your Nytech
DS-8310.
The flash button can be found on the four-way button:
Flash button
With each press of the flash button the flash mode will change. This will be
displayed on the LCD [13] (see page 15 – item 2). The flash must be
charged before it can be used. During recharging, a red point will appear
on the display [13] under the flash icon.
The following flash settings are available:
Icon Description
The flash will fire automatically whenever the shooting
conditions require extra lighting.
A pre-flash will be sent in order for people's eyes to
adapt to the flash. This will reduce the red-eye effect in
your pictures. The flash will fire again to take the photo,
but only when necessary.
The flash will fire always.
The flash will fire for lower shutter speeds (soft flash),
keeping a darker background.
The flash will never fire, even in total darkness.
Figure: Four-way button [7]
To Next Page
Loading...
Need help?
General
