26
eAdvantage User Manual (15PL1033 Rev. 7, July 2022)
Once the update is completed, the device will shut down and restart
automatically. Once it’s on, the technician must confi rm that the
software version shown on the startup page (Fig. 1) is identical to the
revision number written on the new USB key.
Note: Should the update process fail to write the new software to the
device, note the following:
• If the software update failed during the download process – the
orange LED light (G) & Buzzer (E) will activate continuously for 3
seconds and then the mixer will shut down and restart.
• If the USB was disconnected during the update – the orange LED
light (G) & Buzzer (E) will activate continuously for 3 seconds and
then the mixer will shut down and restart.
• If no USB is connected - the following message will appear if the
user pressed the Control Knob (K) without inserting the USB key
“INSERT THE USB KEY AND PRESS THE CONTROL KNOB TO
UPDATE OR PRESS CANCEL TO EXIT”. The message will time out
in 10 seconds.
• If the wrong USB is connected – both the orange LED light (G) &
the battery operation indicator LED (A) will illuminate along with
2x 150 ms bursts followed by 1.5 second continuous Audible Alarm
before the mixer shuts down.
Note: If the User correctly connects the USB key within 5 seconds
the device will start the software update process mentioned above
automatically.
• If the USB key has the wrong software revision – the orange LED
light (G) will illuminate along with 5x 150 ms bursts followed by 1.5
second continuous Audible Alarm and the mixer will shut down.
• If the USB key has the wrong or no fi les – the LED lights (A & G)
will fl ash along with 3x 500 ms ON and OFF audible bursts from
the Buzzer (E) and the mixer will shut down.
• If the device loses power during update – the software update
process will cease and the device will restore the previous revision
until the user updates the software as per the above process.
To Next Page
Loading...