*IMPORTANT – PLEASE READ BEFORE YOU CONTINUE*
PLEASE USE THIS MANUAL IN THIS ORDER:
Step 1:
Use the first half of this manual “General Guide” to set up and calibrate your
instrument. [Including the temperature parameter guide] (Pages 1 - 35)
Step 2:
Then go to the specific parameter guides (eg. pH, Con, TDS etc) which are relevant
to the model you have purchased. (Pg 36 onwards)
CAUTION: Do not skip the general guide as your meter will not be configured to read
accurately if your set-up and calibrations are not done accordingly.
Thank you for reading this page. Please proceed.
To Next Page
