81
This page allows you to set operating parameters for resistivity measurement
mode. The Pure water coeff, Lnr Temp Coefficient, normalization temperature, cell
constant, calibration due, calibration points are set the same way as previously
described in Conductivity set up.
1. Resistivity Setup
The resistivity setup screen presents many options to control the operating
parameters, which can be controlled and set from the resistivity setup screen. The
settings are displayed in 2 pages. Press NEXT-P (F2) and PREV-P (F1) to navigate
through these pages.
Resistivity Settings – Page 1
Figure 38: Resistivity Settings - Page 1
Resistivity Settings – Page 2
Figure 39: Resistivity Settings - Page 2
To Next Page
