Some synlhs, notably the DX-7,
do
not support the Local Control OFF function,
so
when those instruments are used as the master, it may be better not to try to arpeggiate
the built-in voices. You will pruhably want to use a separate master and slave since the
"doubling" problem described above only happens when the master and slave are the
same unit.
RescUing the
CJclolle
The
C)'c1one can be initialized to the condition it left the factory by performing the
"Hard Reset" function. This
is
accomplished by holding the Enter/Enable button
on
the
front panel while tuming on
IXW.'cr.
But be careful: the Hard Reset initializes the
C)'c1one to the default factory settings. This erases all programmed data and replaces
them with the Factory settings.
Unpacking
&
Hookup
Page 13
To Next Page
Loading...
Need help?
General