C.t
-
Manual
Control
The
Manual Control
(C.t)
parameter determines which
of
four functions is enabled by
the Manual Control switch:
Display
tG
tC
dG
dC
Meaning
Transpose Gated
Transpose
Continuous
Double Gated
Double Continuous
Description
The
Holding or Cloning notes are transposed by the
interval defined
by
the number
of
steps between the
transposing note within the Control Zone and the
Base Note (defined below).
If
more than one note
is
held in the Control Zone, the Transpose Priority
parameter is used to determine which note to use as
the transposing note.
If
no notes are held, there is
no
output at all from the CloninglHolding function thus
"gating" the playback.
Same as Transpose Gated, except that the
CloninglHolding function continues as
it
would
normally evenwhen notes in the Control Zone are
released.
The Holding
or
Cloning notes are doubled by each
note held in the Control Zone (up to 8), at intervals
defined by the number
of
steps between the doubling
note within the Control Zone and the Base Note, on
the same MIDI Channel as the Held/Cloning notes.
If
no notes are held, there is no output at all form the
Cloning/Holding function thus "gating" the
playback.
Same as Double Gated, except that the
CloninglHolding function continues as it would
normally even when notes in the Control Zone are
released. Legato playing
of
the control notes results
in an additional double for each such note, up to the
8-double limit, while staccato playing replaces any
previous doubles.
L.n
and
H.n
-
Zone
Limits
The
Control Zone can be placed anywhere on the keyboard, and may overlap with
Zones
1and 2. The
Lo
Note
(Ln)
and Hi Note
(lin)
parameters define the endpoints
of
the Control Zone, and are best defi!led using the Note# sh0l1cut edit described in
"Edit Mode". The
Lo
and Hi Notes cannot "cross". Notes played
in
the Control Zone
will cause the MIDI dot to flash in Play Mode.
b.n
-
Base
Note
The
Base Note (b.n) parameter allows a note to be defined (anywhere on the keyboard)
which is used for computing the transposition and doubling intervals for the Manual
Page 52
Cyclone
Owner's
Manual
To Next Page
Loading...
Need help?
General