Factory Programs, on the other hand, are comprised
of
primarily permanent
ROM
data
plus a limited subset
of
Program Parameters that are actually programmable by the user.
In
other words, there are several parameters in the Factory Programs that you can
change and Store
jf
you want. But for the most part, the Factory Programs' parameters
are pcnnanent. The following parameters an be changed in each Factory Program:
• Current state
of
all play mode flags: Clone On/Off, Cycle On/Off, Manual Cll.
On/Off, Record Ready/Pause/Off/Hold.
• Tempo
• Tempo Modulation Source
• Duration Modulation Source
• Destination
of
Record Duffer
• Destination
of
Keyboard Zones 1 and 2
• Chain Program Number
• Intclllal Pedal 3 and 4 Definitions
• Extcmal Pedal 3 and 4 Dcfinitions
The
Current
Program
The cun'cnt program includcs all the programmable data which
is
active at
anyone
time.
This includes all
of
the PROGRAM parameters and a recording.
The
Master Buffer
hold the parameters that are shared
by
all user and factory programs, and
is
not affected
by selecting
or
storing any program.
Whcn selecting
or
storing to a
factory
Program, only the Program Parameters are
affected; the Recording data from the most recent recording session
or
User Program
is
left intact in the Record Buffer. When a Hard Reset is perfonned, the
Cyclone
copies
. the
factory
Programs (with all factory defaults) to the User Program locations, along
with a
factory Default Recording.
General
Organization
Page
23
To Next Page
Loading...