For
example, to select the ORDER parameter:
• Press "Mode" to enter EDIT mode
• Press the "clone" button until the LED to the left
of
"Order" is lit.
• The display will now show the current value
of
the ORDER parameter.
•
To
change the ORDER, use the "<" and ">" keys
to
change the value.
• When the ORDER is changed, the right dot
in
the display will flash. Press
"Enter" to activate the new value. The dot will stop flashing.
Multiple
Parameter
Pages
Selecting a Page with multiple Parameters/Functions (examples: "Timing...",
"Cycling...", "Control Options...", etc.) results in a 2-character mnemonic display
which identifies the most recently-accessed Parameter
in
that Page. In addition, the
"ParmlMIDI" dot will light to indicate that
it
is
just the name
of
the Parameter, and not
its Value.
At this point, the
"<" and ">" arrow keys are used to select the desired
Parameter/Function within the Page, followed
by
a press
of
the "Enter" key to access
the Value mode as indicated
by
a display
ofa
number. You can then proceed with the
edit as with a single-Parameter Page. Exiting Value mode
is
accomplished
by
hitting
"Enter", any row/column selector,
or
Mode,
or
may happen automatically in the case
of
a Function.
For Example, to change the DURATION
of
each note
to
18
(slightly more than
100%) for a slight legato effect do the following:
• Press "Mode" to enter
EDIT
mode.
• Press the "Cycle" button until the LED
to
the left
of
"Timing
...
"
is
lit.
• The display will now show the name
of
one
of
the parameters at that location:
Pn
(Pulse Note), dU (Duration),
or
Li
(Link). The left display dot is lit to
remind you that this is a parameter
name, not tile value
of
a parameter.
• Use the
"<"
and ">" buttons to select the DURATION (dU) parameter.
• Press the "Enter" button to see the current DURATION.
• Use the arrow buttons to set the duration to
18.
In
this case, the right display dot
does not flash - this change takes place immediately.
For
some parameters, like
the MIDI Basic Channel, the dot would flash and you would have to press
"Enter" here to activate the change and turn
off
the dot.
• Press "Enter" to return to showing
dU
(DURATION).
• You can now select some other parameter
in
"Timing
...
" like LINK using the
"<" and
">"
buttons,
or
you can select some place else in the parameter matrix
by using the rightmost five buttons.
Toggling between PLAY and EDIT modes via the "Mode" switch always accesses the
most recent Page and Parameter/Function.
Page 30
Cyclone
Owner's
Manual
To Next Page
Loading...
Need help?
General