Oberheim TEO-5 - Additional Oscillator Parameters (Program Menu)

19
TEO-5 User’s Guide
Global Settings
create harmonically complex waveforms — particularly when the synced
oscillator’s pitch is set higher than the master oscillator’s pitch. See
“Creating a Hard-Sync Lead” on page 65 to learn how to set up this
type of sound.
Oscillator 1
Oscillator 2
Oscillator 1
synced to
Oscillator 2
Oscillator hard sync
Additional Oscillator Parameters (Program Menu)
Additional oscillator parameters are accessible by pressing the front-
panel program button and scrolling through the list that appears.
Osc 1 Key On: Off, On—When on, oscillator 1 tracks the keyboard or note
data received via MIDI. When off, the oscillator plays at its base frequency
setting, though its pitch may be affected by modulation from other sources.
Osc 2 Key On: Off, On—When on, oscillator 2 tracks the keyboard or note
data received via MIDI. When off, the oscillator plays at its base frequency
setting, though its pitch may be affected by modulation from other sources.
Osc 1 Detune: Fine tune control with a range of +/- 49.2 cents up or
down.
Osc 2 Detune: Fine tune control with a range of +/- 49.2 cents up or
down.
Osc 1 PW: Sets pulse width of the Oscillator 1 pulse wave from
%50-%100 duty cycle, with %50 at minimum pot setting. At %100 the
pulse width narrows to silence.
Osc 2 PW: Sets pulse width of the Oscillator 2 pulse wave.