AcquiSuite Ally 12 & 48 User Guide (Rev D)
9 | P a g e
AcquiSuite™ Ally Meter Safety Summary and Specifications
This general safety information is to
be used by both the Logger operator
and servicing personnel. Obvius, Inc.
assumes no liability for user’s failure
to comply with these safety
guidelines.
AMC12-B-y-z, -P-y-z
AMC48-B-y-z, -P-y-z
AMC12-C-y-z
AMC48-C-y-z
The AcquiSuite™ Family conform to
the following:
AcquiSuite™ Ally 12 & Ally 48:
Conforms to UL Std 61010-1, 3rd
Edition
Certified to CSA Std C22.2 No.
61010-1, 3rd Edition
AcquiSuite™ Ally devices need to be installed in a user-supplied UL Listed/ uR Recognized enclosure in order to comply
with NEC and local electrical codes.
The AcquiSuite™ Ally is an Over-Voltage Category III device. Use approved protection when operating the device.
CAUTION: THIS METER MAY CONTAIN LIFE THREATENING VOLTAGES. QUALIFIED PERSONNEL MUST DISCONNECT
ALL HIGH VOLTAGE WIRING BEFORE SERVICING THE METER WITH THE HIGH VOLTAGE TOUCH SAFE
COVER REMOVED.
Denotes caution. See manual for a description of the meanings.
DENOTES HIGH VOLTAGE. RISK OF ELECTRICAL SHOCK. LIFE THREATENING VOLTAGES MAY BE PRESENT.
QUALIFIED PERSONNEL ONLY.
Equipment protected throughout by double insulation (IEC 536 Class II).
Contains additional information pertinent to current subject
DO NOT EXCEED 346V Line to Neutral or 600 volts Line to Line. This meter is equipped to
monitor loads up to 346V L-N. Exceeding this voltage will cause damage to the meter and
danger to the user. Always use a Potential Transformer (PT) for voltages in excess of 346V
L-N or 600 volts line to line. The AcquiSuite™ Ally is a 600 Volt Over Voltage Category III
device.
To Next Page
Loading...
Need help?
General