Materials 31
Programming roll specifications
If you have inserted a new roll with another copy material or with a different
width, you have to program the Océ 7055/7056. Programming the roll
specifications implies that you instruct the machine of the specifications of the
copy material on the rolls. These specifications are the following:
■
paper or film
■
width of the copy material.
▼
▼▼
▼
Programming roll specifications
1
Open the roll unit.
The display flashes indicating that you are now in programming mode.
2
If necessary, insert a new copy material roll. (see ‘Inserting a new copy
material roll’ on page 24)
3
Press the copy material input button to toggle between roll 1 or roll 2. Select
the roll that you want to program the specifications for.
4
Press the copy material selection button to toggle between paper (paper,
vellum,...) or film.
Attention:
Select the appropriate copy material to avoid flawed copies. All
materials (except for film) should be copied with the copy material
selection set to ‘paper’. Only select the setting ‘film’ if you make copies on
polyester film
5
Close the roll unit.
The specifications of the roll are now programmed.
To Next Page
Loading...
