Copy jobs 13
Making copies
When you use the manual feed option, you can always feed the original or the
copy material. The copying process only starts after pressing the ‘start’ button.
Before pressing the ‘start’ button, you can control and change the settings.
When you use the automatic feed option, you can always feed the original. The
copying process only starts after pressing the ‘start’ button. Before pressing the
‘start’ button, you can control and change the settings.
Note:
After 2 minutes of idleness, the operator panel returns to the ready mode.
When you wait more than 2 minutes between two operations, you have to
restart the procedure.
▼
▼▼
▼
Making copies using the automatic feed option
1
Press the copy material input button until the LED that corresponds with the
roll of your choice lights up. The display shows the width of the selected roll.
Note:
The copy material should be configured as a new roll is inserted. Hence,
as you select a roll, the copy material selection is automatically updated.
2
Select the desired number of copies by pressing the ‘+’ or ‘-’ button on the
operating panel see figure 2.
Note:
Changing the copy quantity can be done at all times. When you make a
mistake you simply press the correction button to correct the copy quantity.
[2] Setting more than one copy using the ‘+’ or ‘-’ button
stop+-start
correction
C
paperpath
add toner
To Next Page
Loading...
