Maintenance
U20944-J-Z247-6-7600
first of which must be a single-byte font and the second of which
must be a double-byte font.
Please see of the ENDBCS parameter from SETUPcuu/control file
for an explanation of the different ways of using SOSI characters
(IBM compatible way and enhanced SOSI processing).
SOSI1 specifies that the SO or SI code invokes the font switch and causes
a blank (X'40') to replace the SOSI code.
SOSI2 specifies that the SO or SI code invokes the font switch only. No
blank is inserted to replace the SOSI code.
Note: Each input line of the print job must start with a single-byte
font. If the line starts with a double-font you must start the line with
an SO control, irrespective of how the last line ended.
TRC Specifies whether the print records contain embedded font table
reference characters (TRC's) to identify the font to be used to print
each record.
DUPLEX={NO |
NORMAL |
TUMBLE}
Specifies whether printing is to be done on one or both sides of
each sheet.
NO Requests printing on the front side of each sheet.
NORMAL
Requests printing on both sides of the sheet such that the sheets
can be
bound on the long edge of the paper.
TUMBLE
Requests printing on both sides of the sheet such that the sheets
can be
bound on the short edge of the paper.
FORMS=form_na
me
Specifies the 1- to 4-character form name.
ROUTER might use the form name you specify, along with the
class and destination values, to route the data set to a particular
remote system.
Notes:
To Next Page
Loading...
