Maintenance
U20944-J-Z247-6-7600
1. Although this parameter is optional, you must specify either a
class, form
name, or destination name to direct the output to a remote system
and
server.
INTRAY=nnn Specifies a number from 1 to 255, which identifies the tray from
which paper is
to be selected. To determine the input tray identifiers for your printer,
refer to
your printer documentation.
OFFSETXB=nnnn[
.mmm]unit
Specifies the offset in the x direction of the logical page origin from
the media
origin for the back side of each sheet. For unit, specify one of the
following
values. ROUTER converts all values to millimeters
IN Specifies a unit of inches
CM Specifies a unit of centimeters
MM Specifies a unit of millimeters
PELS Specifies a unit of picture elements (1/240 inch)
POINTS Specifies a unit of points (1/72 inch)
OFFSETXF=nnnn[
.mmm]unit
Specifies the offset in the x direction of the logical page origin from
the media
origin for the front side of each sheet. For unit, specify one of the
following
values. ROUTER converts all values to millimeters.
IN Specifies a unit of inches
CM Specifies a unit of centimeters
MM Specifies a unit of millimeters
PELS Specifies a unit of picture elements (1/240 inch)
POINTS Specifies a unit of points (1/72 inch)
OFFSETYB=nnnn[
.mmm]unit
Specifies the offset in the y direction of the logical page origin from
the media
To Next Page
Loading...
