Break-in
The first month is most important in the
life of your vehicle. Proper operation
during this break-in period will help
ensure maximum life and performance
from your new vehicle. The following
guidelines explain proper break-in
procedures.
1、After the engine starts, the engine
should not go above 5000rpm for the
first 20 hours.
2、Drive vehicle slowly, do not
accelerate quickly for the first 20 hours.
3、 Avoid slamming the brakes.
4、Do not exceed the vehicle speed on
the below schedule.
Starting and Operating Instructions
● Before starting the engine, be sure
that the driver is seated properly in the
UTV and tighten the seat belts.
● Test the UTV in an open area at the
beginning to learn how to start, turn and
stop.
● Operate the UTV slowly until you
become familiar with it. The turning
radius on this vehicle is very small, so
the centrifugal force is very high when
turning at a high speed. Slow down
around corners or turns to reduce the
risk of overturning your UTV.
To Next Page
Loading...
Need help?
General