and refill if necessary.
Run engine at an idle with the radiator
cap off. Slowly add coolant if necessary.
When the engine reaches normal
operating temperature, press the
throttle level two or three times; then
add coolant if required.
Install radiator cap. Inspect all
connections for leaks and check
coolant level in the reservoir.
Air Filter
Removal
CAUTION: Never remove or modify
any component in the air filter housing.
Poor engine performance or damage
can occur. The engine is calibrated to
operate specifically with these
components.
Remove access panel.
Loosen clamp and remove air filter.
1. Clamp
2. Air filter
Cleaning
Pour cleaning solution or an equivalent
into a bucket. Put the filter in to soak.
While filter soaks, clean inside the air
filter housing.
Rinse the filter with warm water until all
cleaning solution disappears.
Then, let the filter dry completely.
Installation
Properly reinstall removed parts in the
To Next Page
Loading...
Need help?
General