Odyssey 7 - LIMITED WARRANTY

RELEASE NOTES
KNOWN ISSUES
AUDIO
• SDI/HDMI outputs occasionally will not carry audio. Cycle Odyssey power to restore.
• SDI/HDMI audio occasionally will have a static pop when powering up.
• Audio occasionally will swap tracks when recording in DPX.
• Audio output (headphones) occasionally ips channels.
MONITOR
• Focus Assist in Edge Enhanced mode and recording Apple ProRes 422 (HQ) shows edges as
white instead of selected color.
• SDI/HDMI outputs have a pink line in image on Canon C500 2K 12-bit/10-bit video. Recording is
unaffected.
• Switching between ARRIRAW 1.5G DL and 3G DL occasionally can make the image incorrect
on the OLED screen. Disconnect & reconnect one of the SDI inputs to correct. Recording is
unaffected.
• IO Industries RAW les do not send color balance metadata to the Odyssey7Q so images appear
incorrect. Recorded metadata color balance is set to 5600K but is not baked in.
PLAY
• Audio in HD Apple ProRes 422 (HQ) 50p/60p les is out of sync because the Odyssey is
currently playing back audio at 1080 25/30p. Recording is unaffected.
• Very fast scrubbing can show bad colors. The image corrects after scrubbing completed.
• The Playlist occasionally reports timecode as “00:00:00;00”. Eject and re-insert the SSD to correct.
• Multiple clip play is currently supported only in DPX and Apple ProRes 422 (HQ).
• Scrubbing RAW or DPX les occasionally causes the image to pixelate. The image corrects after
scrubbing completed.
• FS700 2K RAW les occasionally show improper colors on initial selection of a clip. De-select and
then re-select the clip to correct.
• FS700 RAW les occasionally show vertical line on right edge of frame. Recording is
unaffected.
• F700 4K RAW 50p les occasionally do not play back audio. Recording is unaffected
• FS700 RAW 30p and 60p les occasionally play with jitter. De-select and re-select to correct.
Recording is unaffected.
RECORD
• Audio at the last few frames of an Apple ProRes 422 (HQ) le occasionally records static. Add two
seconds of pre- and post-roll to shots to avoid.
• ARRIRAW 4:3 mode is currently unsupported.
EARLIER VERSIONS
Please see our website for release notes for earlier rmware versions.
50