50
RS232 COMMAND TABLERS232 COMMAND TABLE
RS232 COMMAND TABLERS232 COMMAND TABLE
RS232 COMMAND TABLE
CommandCommand
CommandCommand
Command
CharacterCharacter
CharacterCharacter
Character
DescriptionDescription
DescriptionDescription
Description
??
??
? Print current mode
nnnAnnnA
nnnAnnnA
nnnA Set Auto Print feature to “nnn”
(see table).
CC
CC
C Begin span calibration
xDxD
xDxD
xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
EE
EE
E Exit parts counting or percent weighing
xx
xx
x
II
II
I Set Averaging Level to “x”,
where x = 0 to 3 (see table).
LL
LL
L Begin linearity calibration
MM
MM
M Same effect as pressing mode button
xMxM
xMxM
xM Places balance in mode “x”,
where x = 1 to 13 (see table).
If unit or mode is not already
enabled, command will be ignored.
Field: Mode Stab CR LF
Length: 5 1 1 1
blank if stable
“ ? ” if unstable
1 = grams
2 = pennyweight
3 = carats
4 = avoidupois ounces
5 = troy ounces
6 = grains
7 = taels
8 = momme
9 = pounds
10 = pounds:ounces
11 = custom unit
12 = parts counting
13 = percent weighing
nnn = 0 Turns feature OFF
nnn = S Output on stability
nnn = C Output is continuous
nnn = 1-256 Sets Auto Print
Interval
0 = minimum level
1=
2=
3 = maximum level
Grams
Pennyweight
Carats
Avoidupois ounces
Troy ounces
Grains
Taels
Momme
Pounds
Pounds:ounces
Custom unit
Parts counting
Percent weighing
Error
To Next Page
Loading...
