OHAUS TP200S - Print Numeric Data Only; List; End

46
Print Numeric Data OnlyPrint Numeric Data Only
Print Numeric Data OnlyPrint Numeric Data Only
Print Numeric Data Only
This submenu is used to select numeric
data only, or full display data for RS232
output. Set this feature ON to output nu-
meric display data only, or OFF to output
full display data as follows:
1. Access the Nu submenu to display
the current status.
2. Press
to change the status.
3. Press
to accept the displayed
status.
When
is released, NU will be dis-
played again and the Print menu will be
returned.
ListList
ListList
List
This submenu can be used to output a
listing of current menu settings via the
RS232 interface. When selected, menu
settings for both the Setup and Print menus
will be output. To obtain a listing of current
settings, press when LIST is dis-
played.
EndEnd
EndEnd
End
You must use End to exit the Print menu.
Changes you make in the Print menuChanges you make in the Print menu
Changes you make in the Print menuChanges you make in the Print menu
Changes you make in the Print menu
are only stored in memory if you useare only stored in memory if you use
are only stored in memory if you useare only stored in memory if you use
are only stored in memory if you use
EndEnd
EndEnd
End
To exit the Print menu and store your
selections, press
when END is dis-
played. The balance will be returned to
normal weighing operations.
MODEMODE
MODEMODE
MODE
ONON
ONON
ON
TARETARE
TARETARE
TARE
ONON
ONON
ON
TARETARE
TARETARE
TARE
ONON
ONON
ON
TARETARE
TARETARE
TARE
ONON
ONON
ON
TARETARE
TARETARE
TARE