PAGE 16
© 2022 OJ Electronics A/S
7.5 Set the floor load
Floor load is used to calculate the energy consumed by the floor heating system.
This setting has no eect on floor heating operation
1. Set the load of the underfloor heating system to be controlled by the thermostat.
2. Tap the “Arrow Right” button to continue.
This setting is used for energy calculation only and has no influence on the opera-
tion of your heating system.
If you do not know the value for your floor, leave it at the default. This setting can be
changed later if a factory reset is performed
1
2
To Next Page
Loading...
