Troubleshooting> 130
8. Remove any sheets of paper as follows:
• To remove a sheet with its leading edge at the front of
the belt (1), carefully lift the sheet from the belt and
pull it forwards into the internal drum cavity and
withdraw the sheet.
• To remove a sheet from the central area of the belt,
carefully separate the sheet from the belt surface and
withdraw the sheet.
• To remove a sheet just entering the fuser , separate
the trailing edge of the sheet from the belt, push the
fuser pressure release lever (1) towards the front and
down to release the fuser’s grip on the sheet, and
1
CAUTION!
Do not use any sharp or abrasive objects to separate
sheets from the belt. This may damage the belt surface.
1
To Next Page
Loading...
Need help?
General
