Oki C712 User Guide

Maintenance > 59
10. Holding the complete assembly by its top centre, lower it into place in the printer,
locating the pegs at each end into their slots in the sides of the printer cavity.
11. Finally, close the output tray and press down firmly at both sides so that the cover
latches closed.
R EPLACING THE TRANSFER BELT UNIT
The belt unit is located under the four image drums.
Switch off the printer and allow the fuser to cool for about 10 minutes before opening the
cover.
1. Press the cover release and open the printer’s output tray fully.
2. Note the positions of the four toner cartridges (a) and image drums (b). It is
essential that they go back in the same order.
NOTE
If you need to return or transport your printer for any reason, please make
sure you remove the image drum unit beforehand and place in the bag
provided. This is to avoid toner spillage.
WARNING!
If the printer has been powered on, the fuser will be hot. This area
is clearly labelled. Do not touch.
a
b

Oki C712 Specifications

General

Printer Type	Color Laser Printer
Print Technology	LED
Resolution	1200 x 1200 dpi
Monthly Duty Cycle	100, 000 pages
Memory	512 MB
Paper Capacity	up to 1, 690 sheets maximum
Connectivity	USB 2.0, Ethernet, Wi-Fi
Media Sizes Supported	A4, A5, A6, B5, Legal, Letter, Executive
Operating Systems Supported	Windows, Mac, Linux
Duplex Printing	Automatic