- 79 -
5. Management / Setting the Printer
• USB Setup
•Print Setup
*1 : Factory default setting values are different according to the country or region.
• PS Setup (C834/C844/ES8434)
•PCL Setup
IPSec Disable Displayed only when [IPSec] is enabled and only the
change to disable is available.
SNMP Enable Sets whether to enable SNMP.
Network Scale Normal When [Normal] is selected, the printer works effectively
even if connected to a hub that has the spanning tree
feature. However, the start-up time of printer becomes
longer when the printer is connected to a small LAN that
consists of two or three computers.
Gigabit Network Disable Sets whether to enable access with Gigabit Ethernet.
Hub Link Setting Auto Negotiate Sets the hub linking method. Normally, select [Auto
Negotiate].
Network Factory Defaults Execute Initializing the network menu
Item Factory Default Description
USB Enable Sets eable/disable of USB I/F.
Speed 480 Mps Selects the maximum transfer speed of USB interface.
Soft Reset Disable Sets Enable/Disable of Soft Reset command.
Serial Number Enable Specifies Enable/Disable of a USB serial number.
Offline Receive Disable Sets whether to receive data when an alarm is present.
(Except C824)
USB Memory Interface Enable Sets eable/disable of USB Memory I/F.
Connected Host Normal To prevent a timeout error occurring when a job is sent to
the machine in sleep mode, set to [Specific].
That requires more energy during sleep mode than the
[Normal] mode.
Item Factory
Default
Description
Personality Auto Selects the emulation mode.
Copies 1 Sets the number of copies.
Duplex On or Off *
1
Sets the duplex printing.
Binding Long Edge Sets the binding position for duplex printing.
Media Check Enable Sets whether to check if the paper size of the tray and
the page size of the document do not match.
A4/Letter Override Yes Automatically switches paper to print from A4 to Letter if
A4 document is to be printed with A4 paper run out and
Letter paper loaded, from Letter to A4 if Letter document
is to be printed with Letter paper run out and A4 paper
loaded.
Item Factory Default Description
Resolution 600 dpi Sets the resolution.
Toner Save Toner Save
Level
Off Sets the amount of toner to be saved.
Color All [All]: Toner Save is applied to all colors including 100%
black.
[Except100%Black]: Toner Save is applied to all colors
other than 100% black.
This function is only applied to the print function.
Mono-Print Mode Auto Sets the print mode for black-and-white pages.
Default Orientation Portrait Sets the print orientation. Not available for PS data.
Edit Size Cassette Size Sets the size of the printable page area when no
command to specify the paper edit size is sent from the
computer.
Trapping Off Sets when white stripes appear between adjacent colors.
X Dimension 210 millimeter
or 8.5 inch *
1
Sets the width of a custom paper size.
Y Dimension 297 millimeter
or 11.0 inch *
1
Sets the length of a custom paper size.
Item Factory Default Description
L1 Tray Type1 Sets the paper tray number for the Level 1 operator
command.
Network Protocol RAW Specifies PS communication protocol mode of data from
Network.
USB Protocol RAW Specifies PS communication protocol mode of data from
USB.
PDF Paper Size Current Tray Size Set the paper size when printing with PDF Direct Print.
PDF Scaling Size 99 % Sets reduction rate for PDF when [PDF Paper Size] is
set to [Scaling Size].
PDF Print Mode Quality priority Sets whether to give priority to the print quality or the
print speed when printing PDF.
Item Factory
Default
Description
Font Source Resident Selects the location of the font to use.
Font Number I0 Selects the font number to use.
Item Factory
Default
Description
To Next Page
Loading...
Need help?
General
