Oki C910 - Density Correction

Oki Data CONFIDENTIAL
44043511TH Rev.2
177 /
5.3 Density Correction
When the printer is shipped, the Automatic Density Correction Mode is set to “On”. If it is set to “Off”
there may be drifting during use. Set this if there is any problem with the density.
Note! Set this when the printer is not running (Stop State). Do not set this while the printer
is warming up.
(1) Press the [MENU+] or [MENU-] key several times to select [Calibration]. Then press
the [ENTER] key.
(2) Press the [MENU+] or [MENU-] key to display the [Adjust Density/Execute].
(3) Press the [ENTER] key.
Automatic Density Correction starts.