Oki Data CONFIDENTIAL
44043511TH Rev.2
280 /
Function
LCD
Status Message Help Message
Shows the belt unit of the printer is not properly
installed.
Check Belt Unit
Please see HELP for details
Error Code: 330
[Context]
The belt unit is not installed
properly.
[Action]
Turn off the printer power and
proceed as follows.
Open the printer top cover.
Remove the four drums and
place on the level surface.
Cover the drums with paper.
Move the blue locking levers at
the front and back of the belt
unit to the left, lift out the belt
unit by the blue handles on
each side and then reinstall.
Move the blue locking levers at
the front and back to the right.
Reinstall the four drums.
Close the printer top cover.
Turn on the printer power.
Shows an error that the printer has no waste toner
box or the front cover of the printer is open, pausing
printing of the printer. Opening and closing the cover
of the printer places the printer in the notification
state.
Check Waste Toner Box
Please see HELP for details
Error Code: 331
[Context]
The waste toner box has not been
installed correctly.
[Action]
Raise the control panel.
Hold both sides of the printer's
front cover to open.
Pull out the waste toner box
while pressing the blue lever
on its upper right side and then
reinstall it.
Close the printer front cover.
Shows the cover of the printer is open.
Error 310 : Top Cover
Error 589 : Tray1 Side Cover
Error 312 : Tray2 Side Cover
Error 313 : Tray3 Side Cover
Error 314 : Tray4 Side Cover
Error 315 : Tray5 Side Cover
Error 316 : Duplex Unit’s Cover
Error 317 : Finisher’s Top Cover
Error 318 : Finisher’s Front Cover
Error 319 : Inverter’s Cover
Error 311 : Side Cover
Error 588 : Exit’s Side Cover
Close Cover
%COVER%
Please see HELP for details
Error Code: nnn
[Context]
The cover is open.
[Action]
Close the indicated cover.
Shows the controller unit of the printer is being
rebooted. The cause of the reboot appears in the
portion of n, which is a one-digit decimal number.
= 0 … Not any of the following.
= 1 … A PJL command.
= 2 … Menu-operated change.
= 3 … A PostScript quit operator.
= 4 … A network utility (such as Web)
Wait a Moment
Rebooting <n>
–
To Next Page
Loading...
