OkiLAN 8100e Network User’s Guide
UNIX - 120
# /usr/sbin/lpadmin -p PRINTER_lp -I postscript
d. Start the print scheduler.
# /usr/sbin/lpsched
e. Activate the print queue.
# /usr/sbin/accept PRINTER_lp
f. Enable the print queue
# /bin/enable PRINTER_lp
To customize output, for example to add additional commands at
the start of each print job, you can edit a copy of the netstandard
model file then add it using the lpadmin command
Example: for printer PRINTER_lp, with model file called
PRINTER0_model
# /usr/sbin/lpshut
# /usr/sbin/lpadmin –p PRINTER_lp –m
PRINTER_model
# /usr/sbin/lpsched
HP-UX 10.x configuration
If an incorrect IP Address, Subnet Mask or Gateway is entered, the
network may go down or other damage may occur. Check the
address with the network manager.
The following example uses HP-UX10.20 and an OKI printer as
examples. The absolute path and method of configuring commands
may differ in other versions of the OS. Refer to the workstation
manual for more details.
1. Confirm that the IP address of the printer has been set. See
network interface card IP address configuration for more
information.
To Next Page
Loading...
