OkiLAN 8100e Network User’s Guide
Configuration - 15
Using Quick Setup
Quick Setup utility allows you to configure the print server easily
and simply without installing any software packages.
You can configure the following:
> Enable/disable TCP/IP, NetWare, EtherTalk, NetBEUI
protocols.
> Set IP address, Subnet Mask and Gateway for TCP/IP
manually or by using DHCP.
> Set NetWare mode and create Queue/Print Server/Printer
objects.
> Zone name and Port name for EtherTalk.
Configuration requires a PC with Windows 95/98/Me, Windows
2000 Advanced Server/Professional or Windows NT Server 4.0/
Work-station 4.0, Windows XP running TCP/IP or IPX/SPX
(NetWare).
This utility can only be used on a PC that can be connected to the
network with TCP/IP or IPX/ SPX.
This utility must be used on a PC that is located in the same
segment as the printer. To create a NetWare queue, NetWare
Client 32 or IntranetWare Client should be installed in your system.
The following explanation uses Windows 98 as an example.
1. Insert the CD-ROM provided with your printer into the
CD-ROM drive. If the Menu Installer does not start
automatically, click Start → Run → Browse. Browse to your
CD-ROM and click Install → Open → OK.
To Next Page
Loading...
