Oki lan 8100e - Page 39

OkiLAN 8100e Network User’s Guide
Configuration - 39
Printer Trap
Setup . . .
By selecting the button, the following dialogue box is
displayed:
bmp32.bmp
In the dialogue box, the following items can be configured:
Printer Trap
Community Name
This community name is assigned to
outgoing printer status traps such as
off-line, paper out, etc.
TCP#1—5 Set the IP address to which a Trap
packet will be sent. You can set up to
five IP addresses.
Detail . . . By selecting the button, the following
dialogue box is displayed:
bmp33.bmp
In the dialogue box, the following items
can be configured:
Trap Enable Set sending a Trap
packet, enabled or
disabled, for each
destination.
On-Line Set sending a Trap,
enabled or
disabled, when the
printer turns to
On-Line.
On-Line Set sending a Trap,
enabled or
disabled, when the
printer turns to
Off-Line.
Paper Out Set sending a Trap,
enabled or
disabled, when
paper is out.
Location Comments