- 89 -
Scanning to Computer
4
Scanning
9 Enter the DNS server and WINS server if
needed.
If it is not necessary to connect the DNS server
or WINS server to the network, press
OK
until the
pop-up message showing setting completion is
displayed.
10 When the setup menu screen is
displayed, press
to complete the
setup.
11 For the conrmation message, check
that [Yes] is selected and press
OK
.
◆ Print the Network Information to check that
the IP address and other network information
are properly set.
1 Press the <SETTING> key on the
operator panel.
2 Check that [Reports] is selected and
press
OK
.
3 Press the to select [System] and
press
OK
.
4 Press the to select [Network
Information] and press
OK
.
5 For the conrmation message, check
that [Yes] is selected and press
OK
.
The Network Information is printed.
Step 2 Installing Your Machine to the
Computer
Memo
● The following procedure installs the WIA driver as a
scanner driver automatically.
1 Click [Start] and select [Control
Panel].
2 Select [Network and Internet] >
[Network and Sharing Center].
3 Select [Change advanced sharing
settings].
4 Check that [Turn on network
discovery] is selected.
5 Close the Control Panel.
6 Click [Start] and select [Network].
The devices connected to the network are
displayed.
7 Right-click the MC362 icon under
[Multifunction Devices] and select
[Install].
If the [User Account Control] dialog box is
displayed, click [Yes].