Getting started > 23
S
LEEP
MODE
Your machine transitions from power saving mode to sleep mode after a set period of time.
In sleep mode the power consumption of the device in minimal. To cancel or initiate sleep
mode, press the Power Save button on the control panel.
NOTE
The machine will not enter sleep mode if an error occurs and the machine
requires attention.
By default, the time interval to enter sleep mode is set to 30 minutes. Refer
to “Sleep Time” on page 187.
You can enable or disable sleep mode. Refer to “Sleep” on page 189.
> When the network connection is switched from wired to wireless, sleep
mode is disabled. To enable sleep mode for devices connected using
wireless LAN, enable sleep mode from the sleep mode setting menu.
(MC342dw, MC362w, MC562w, MC562dw, ES5462dw MFP, MPS2731mc
only)
> When a device using the wireless LAN connection goes into sleep mode, the
wireless LAN connection is broken. To reconnect to the wireless LAN, press
the power save mode on the device to recover from sleep mode.
(MC342dw, MC362w, MC562w, MC562dw, ES5462dw MFP, MPS2731mc
only)
> After the device connected to the wireless LAN has recovered from sleep
mode, it automatically connects to the wireless access point using the same
settings as before it went into sleep mode. However, it may take up to
1 minute to connect. (MC342dw, MC362w, MC562w, MC562dw, ES5462dw
MFP, MPS2731mc only)
> When the network connection is switched from wireless LAN to wired LAN,
sleep mode is enabled. (MC342dw, MC362w, MC562w, MC562dw,
ES5462dw MFP, MPS2731mc only)
> Depending on your network environment, your computer may wake from
sleep mode immediately. If this happens, it is recommended that you
disable sleep mode.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
